He arrived 10 days ahead of what I expected. Combined with the chainsaw which also came quickly, and I tried it and it's perfect, I'm very satisfied

Ήρθε 10 ημέρες πριν από ότι περίμενα. Σε συνδυασμό με το αλυσοπρίονο που και αυτό ήρθε γρήγορα, και το δοκίμασα και είναι τέλειο, είμαι πολύ ικανοποιημένος

He arrived 10 days ahead of what I expected. Combined with the chainsaw which also came quickly, and I tried it and it's perfect, I'm very satisfied

The product gives the impression of a quality product. The stones that come with it will do the job. We sharpened the chainsaw with 7/32 stones. It is quite practical to know. The 20,000-cycle engine does a pretty good job. The chain was pretty sharp. The collet next to the product is 3mm in diameter. The 4.8mmx17mm engraving collets attached to the 3.17mm chucks fit perfectly. I used the clamps set that I attached to the picture. I tried to drill holes in the product. I installed a 30mm diamond disc and cut the PCB. Its 55W motor works for minor cutting drilling operations. It can be taken, it can be used not only for chain sharpening but also for other hobby work. What you need to do is get the collet sets that are attached to the 3.17 mm chucks.

Ürün kaliteli bir ürün izlenimi veriyor. Yanında gelen taşlar iş görür. 7/32 taşla motorlu testere zincirini biledik. Elde bilemeye göre oldukça pratik. 20.000 devir dönen motoru oldukça iyi iş çıkarıyor. Zincir oldukça keskin oldu. Ürünün yanında gelen pens 3mm çapında. 3.17mm mandrenlere takılan 4.8mmx17mm boyundaki gravür pensleri tam uyuyor. Ekte resmini koyduğum pens setini kullandım. Ürüne matkap ucu takarak delik delmeyi denedim. 30mm'lik Elmas disk takıp PCB kestim. 55W'lık motoru ufak kesme delme işlemlerinde iş görüyor. Alınabilir, sadece zincir bileme değil diğer hobi işlerinde de kullanılabilir. Yapmanız gereken 3.17 mm mandrenlere takılan pens setlerinden almak.

The product gives the impression of a quality product. The stones that come with it will do the job. We sharpened the chainsaw with 7/32 stones. It is quite practical to know. The 20,000-cycle engine does a pretty good job. The chain was pretty sharp. The collet next to the product is 3mm in diameter. The 4.8mmx17mm engraving collets attached to the 3.17mm chucks fit perfectly. I used the clamps set that I attached to the picture. I tried to drill holes in the product. I installed a 30mm diamond disc and cut the PCB. Its 55W motor works for minor cutting drilling operations. It can be taken, it can be used not only for chain sharpening but also for other hobby work. What you need to do is get the collet sets that are attached to the 3.17 mm chucks.