A part of the review has been auto-translated.
The good: I've used the stock sheet, mirror plates, glass plates and finally this. This is by far the best hassle free solution there is. Thanks to the top layer pattern, I have not bothered with using adhesive products to make sure my prints would stick properly. To remove them, all I have to do is wait for the bed to cool off and I can remove objects with minimal effort. It makes printing so easy. I want to be clear here - thanks to this surface I have managed some of the most effortless prints and maintenances since I've owned my printer. I will definitely buy again. but... The bad: While some versions of this bed come with a more subtle CREALITY logo at the bottom edge, some (like mine) come with the logo written in bold large letters across the middle. It looks great but the logo's print material itself has just enough thickness to leave the CREALITY logo on your finished surface. This does NOT affect your bed levelling, it only creates a very subtle shadow. Surface finish: Logo issues aside, the finish is very nice and smooth, however, it is not uniform like a glass or mirror finish would produce. There are subtle grooves in the pattern which give a nice unique surface. Tip: Even if you can stick this plate to the bed, you may want to keep it on without adhesive so you can change to different finishing surfaces. That being said, mine is glued on and I do regret doing so since I would have re-ordered another bed without the logo if I had known.
Great printbed! Just wipe it down with isopropyl alcohol and make sure you have your bed leveled and dialed in for that first layer squish. Good adhesion and easy to remove prints from the bed after cooling. Very nice finish on the bottom of the print. Can work with glue stick or hairspray. Comes very nicely packaged. Thanks a lot, Banggood!