Customer Reviews

5 out of 5
See all 4 reviews
Write a Review
  • All Reviews (4)
  • Image (0)
  • Video (0)
  • All Star
    • All Star(4)
    • 5 Star(4)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United Kingdom)
|
Show Original

A part of the review has been auto-translated.

  • 20/02/2020

    The relay board appears to work well. The only issue is a lack of documentation. After significant search time I have found some things. The board came pre-loaded with a WiFi scan program. After hooking it up to a serial monitor it reported a list of the visible WiFi networks. I was able to program it using the Arduino IDE as a Generic ESP8266 module. Use P6 right next to the power terminals. The pins are labeled TX. RX. & GND. This is a serial port to upload the software. P5 right next to it is the Boot terminal. If these pins are connected together when the board is powered up,it goes into boot mode, ready to receive a software load. I had to update to version 2.6.3 of the ESP8266 package to get reliable programming. The builtin LED is on GPIO 2. The relay control is on GPIO 4. The Optocoupler input is on GPIO 5. The pins for the input are +5v from the on-board buck converter, Optocoupler IN, and Optocoupler ground. The Optocoupler ground is NOT connected to the board ground.

    Comments
    Show Original
  • 23/10/2020

    Work well - can be flashed with Tasmota, fast delivery!

    Comments
    Show Original
  • 11/03/2020

    all ok

    Comments
    Show Original
  • 05/07/2019

    Superpack! Thank You!

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go
    recommendation for you
    • US$3.99
    • US$6.99
    • US$8.99
    • US$4.99
    • US$19.99
    • US$11.99
    • US$10.99
    • US$33.59
    • US$60.14
    • US$18.99
    • US$19.39
    • US$55.28
    • US$7.99
    • US$4.99
    • US$11.48
    • US$23.99
    • US$23.99
    • US$5.99