2020-04-23 12:14:34

corner ok, nuts ok but SCREWS ARE TOO LONG !! cannot use as it ... need shorter screws or shimes ! anyway, need an other order, not on banggood les coins ok, les écrous ok mais LES VIS SONT TROP LONGUES !! du coup le coin n'est pas fixé. c'est des 10mm, il faut moins, 8mm devrait aller sinon il faut rajouter des rondelles ... en tout cas le kit n'est pas utilisable sans un autre achat !

2020-04-01 20:44:50

I used this on a upgrade of my 3D pinter, It worked fine but be aware that if they are near a wheel or rail bits hanging down may hit the "triangle" I just used my dremel to make the clearance.

2020-06-22 06:46:59

Les vis sont trop longues, j’ai dû ajouter des rondelles.

2020-06-01 08:56:58

top

2020-05-14 05:34:40

value for money here

2020-03-27 22:29:33

Would be better if there were some washers for the m5 screws. But overall very good.

2020-03-15 12:27:30

Good parts for 3D printer !!

2020-02-12 09:00:44

Good Quality