Precise details:
Description:
ESP-15F is a powerful WiFi module. The core processor of the module, ESP8266, integrates the industry-leading Tensilica L106 ultra-low power consumption 32-bit micro MCU in a small size package with a 16-bit streamlined mode and main frequency Support 80MHz and 160MHz, support RTOS, integrated WiFi MAC/BB/RF/PA/LNA.
ESP-15F WiFi module supports standard IEEE802.11b/g/n protocol, complete TCP/IP protocol line. Users can use this module to add Internet functions to existing equipment, or build an independent network controller.
Features:
1. Complete 802.11b / g / n Wi-Fi SoC module
2. The core is Tensilica L106 low power 32-bit MCU, frequency supports 80 MHz and 160 MHz, supportsRTOS
3. Built-in 10-bit high-precision ADC
4. Only support UART interface
5. Using the PH2.54 connector/DIP-8 package
6. Integrated Wi-Fi MAC/ BB/RF/PA/LNA
7. Support multiple sleep modes, the standby power consumption as low as 1.0mW
8. UART baud speed up to 4Mbps
9. Embedded Lwip protocol stack
10. Support STA/AP/STA+AP operation mode
11. Smart Config (APP) / AirKiss (WeChat) support for Android and IOS
12. Support serial port local upgrade and remote firmware upgrade (FOTA)
13. General AT commands can be used easy and quickly
14. Support for second development, integration of Windows, Linux development environment
15. Support 5V power supply
Product Parameters:
Model: ESP-15F
Interface: PH2.54 connector / DIP-8 package
Antenna form: onboard PCB antenna / IPEX external antenna
Spectrum range: 2400~2483.5MHz
Working temperature: -20°C~70°C
Storage environment: -40°C~125°C, <90%RH
Power supply range: voltage: 5V, current> 800mA
Support interface: only support UART
IO: 3 (reserved)
Serial port rate: support 110~4608000 bps, the default is 115200 bps
Security: WEP / WPA-PSK / WPA2-PSK
SPI Flash: default 32Mbit
Product size: 41.3 * 24.1 * 6.6 (+0.2) MM (L * W * H, the height is subject to the needle seat).
Pin Definition:
TXD: UARTO_ TXD (default 5V)
RXD: UARTO_ RXD (default 5V)
GND: Ground
VCC: The output current of the external power supply is recommended to be above 800mA
IO4: GPIO4 reserved interface
IO0: GPIO0; Download mode: pull down externally, operating mode: float or pull up externally Reserved interface
EN: chip enable terminal, active at high level, reserved interface
IO5: GPIO5 reserved interface
Package Included:
1 x ESP-15F WiFi module