Customer Reviews

4.81 out of 5
Write a Review
  • All Reviews (26)
  • Image (2)
  • Video (0)
  • All Star
    • All Star(26)
    • 5 Star(24)
    • 4 Star(1)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(1)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
  • acmenet
    GB
    2019-07-06 07:23:27

    looks good, arrived fast

    Comments
  • 2017-11-06 06:35:25

    Mandrino ER11 di ottima qualità

    Comments
  • 2020-06-05 03:37:02

    Firstly, the spindle arrived in good time. I bought a couple of these from different vendors to compare the quality. This one is the slightly more expensive of the two, but still very cheap. On first look I notice that the nut thread is rough. I have done quite a bit of threading on an industrial scale and can see immediately on this one I received the threads are tearing along the apex; before they get to this state the threading cutters should be changed for new ones. Having said that, the nut

    Comments
  • omang
    AU
    2020-01-06 16:27:36

    Looks fairly good, need to check it for fit of collets. The threads are not smooth the feel gritty, I'll see what they are like once I have cleaned them up.

    Comments
  • Susanne
    DE
    2020-06-06 02:11:33

    habs eingekürzt für makita läuft super

    Comments
  • 2020-02-21 22:49:30

    Good chuck!

    Comments
  • 2020-02-11 16:48:05

    How cheap!!!!?

    Comments
  • ilovrc2
    CA
    2020-01-01 14:36:17

    Item as described.

    Comments
  • 2016-01-05 16:02:11

    Chuck was described as 'high precision' but turned out to be 0.01mm accuracy, a nice surprise. External finish looks quite good. After opening my chuck, I found that the inside was serious corroded, resulting in no precision more at all. :-( Hopefully this was an incident, due to wrong application of protecting oil. Refund was made without any problem. Good service. :-) I have high expectations about the new chuck, because the description now even promisses an accuracy of 0.003!

    Comments
  • 2015-12-30 11:02:42

    Думал, что Китайские валы, будут не очень. Однако, под микрометр всё промерил, вал действительно 10.00 на всей длине, посадка в подшипник будет плотная. Балансировку не проверял, но цанга думаю выдержит без биения 25-30 тысяч оборотов в минут. В общем вал мне понравился, буду делать

    Comments
Show:

    Go to page

    Go

    You might be interested in

    recommendation for you
    • £7.53
    • £3.85
    • £4.18
    • £4.78
    • £1.92
    • £3.18
    • £13.39
    • £7.17
    • £2.39
    • £3.98
    • £20.73
    • £2.39
    • £7.17
    • £7.97
    • £2.77
    • £4.78
    • £3.18
    • £4.78