The printer is really good, but it needs a little help: _- I leveled the HB using the Klipper web interface (Bed Mesh)_- I flashed the firmware, the one that goes via the USB stick (there was one, without a version number ...)_- everything needs to be lubricated (I even lubricated the filament cooling fan)_- in Orca Slicer, tweak the profile a bit (Z hop when retracting 0.3 mm, reduce infill retraction off) __Filament exchanges well. _Klipper is great, especially the web interface. _So, you have to learn something too.

Tlačiareň je fakt dobrá, ale je treba trochu tomu pomôcť : - vyrovnal som HB pomocou web.rozhrania Klipperu (Bed Mesh) - preflešol firmware, ten čo ide cez USB kľúč (bol tam taký, bez čísla verzie ...) - všetko namazať treba (aj vetrák chladenia filamentu som mázol) - v Orca Sliceru trochu poladiť profil(Z hop when retracting 0.3 mm, reduce infill retraction off) Filament sa dobre vymieňa. Klipper je skvelý hlavne web.rozhranie. Tak, treba sa niečo aj naučiť.

The printer is really good, but it needs a little help: _- I leveled the HB using the Klipper web interface (Bed Mesh)_- I flashed the firmware, the one that goes via the USB stick (there was one, without a version number ...)_- everything needs to be lubricated (I even lubricated the filament cooling fan)_- in Orca Slicer, tweak the profile a bit (Z hop when retracting 0.3 mm, reduce infill retraction off) __Filament exchanges well. _Klipper is great, especially the web interface. _So, you have to learn something too.

very fast delivery and top goods _would gladly order again.

sehr schnelle Lieferung und top Ware gerne wieder.

very fast delivery and top goods _would gladly order again.