Very good 4in1 esc. Telemetry works perfectly with Kiss FC. You can get current reading.

Very good 4in1 esc. Telemetry works perfectly with Kiss FC. You can get current reading.

Very good 4in1 esc. Telemetry works perfectly with Kiss FC. You can get current reading.

works and in very good condition! recommends

fonctionne et en très bonne état ! recommande

works and in very good condition! recommends

best 4x ESC available

best 4x ESC available

best 4x ESC available

1a ok

1a ok

1a ok

love it. very smooth flights

love it. very smooth flights

love it. very smooth flights

Typhoon 32V2 -я им доволен, работает хорошо.

Typhoon 32V2 -я им доволен, работает хорошо.

Typhoon 32V2 -я им доволен, работает хорошо.

ok

ok

ok

nice large solder pads

nice large solder pads

nice large solder pads

its very Good and a small Design for my Race Copter

its very Good and a small Design for my Race Copter

its very Good and a small Design for my Race Copter

Chips ( Mosfets) far too close to mounting holes for use of normal standoffs. Should be a little wider with perhaps slightly larger pads for the motor wires. Also, if you want your battery wires coming straight out of the back of quad, the motor position will need reprogramming in CLI. Plus, unless you want your batt wires in vertical plane, the pads are too small for flat on soldering. Other than that, it's a good 4 in 1 lol.

Chips ( Mosfets) far too close to mounting holes for use of normal standoffs. Should be a little wider with perhaps slightly larger pads for the motor wires. Also, if you want your battery wires coming straight out of the back of quad, the motor position will need reprogramming in CLI. Plus, unless you want your batt wires in vertical plane, the pads are too small for flat on soldering. Other than that, it's a good 4 in 1 lol.

Chips ( Mosfets) far too close to mounting holes for use of normal standoffs. Should be a little wider with perhaps slightly larger pads for the motor wires. Also, if you want your battery wires coming straight out of the back of quad, the motor position will need reprogramming in CLI. Plus, unless you want your batt wires in vertical plane, the pads are too small for flat on soldering. Other than that, it's a good 4 in 1 lol.