R8 FMB22 Arbor Morse Taper for 400R 50mm Face Mill Cutter
A part of the review has been auto-translated.
Received well protected in its plastic case with cap screw, Preform well as expected , quality at an affordable price, ZERO runout on the mill , precice and cocentric register for the face mill , ONE thing a would improuve is the lenght of the cap screw, at 16mm its too short to hold on to the face mills, in the photos you see a 25 mm cap screw , for some reason I got a 16mm((( Hopefully BG will make shure the supplier gets is right the next time , Still giving 5 stars a 10X1.5 cap screw is not so hard to find!
Item arrived on time and well protected in its plastic case ,well oiled and in a heavy plastis bag. The finish and fit is excellent . Very happy with these arbors I have 5 of them so definetlly recommend. Excellent value for the price.
Reasonably priced arbor that does the job. Not the most precisely machined arbor I have seen. There was a bit of slop when I fitted the 400R 50mm Face Mill but I was able to remove most of it by cinching down the retaining socket head screw. Bottom line, it works but don't expect a lot as far as being accurately machined.
Parts have excessive run out. 0.008(0.2mm/. Other than that-nice cutter 22mm dia has 0.1mm (0.004") run out in Bridgeport spindle. Ann the cutter and the run out goes to 0.2mm (0.008"). You should be able to do a lot better with some care and practice
Excellent finish
My item arrive early then I expected and fits directly
I used this arbor for my 400R-50mm-22 face mill. It is nicely machined and holds the face mill very accurately with no runout. I would recommend this item to other buyers.
Great product works well but did not get M10 screw with it so had to order some from other supplier
fit and finish are great. very close tolerances. I am very happy with this arbor.
product arrived quickly and in good condition, one gripe is that the cap head bolt is not long enough to put a face mill on. I have not tested it yet but it looks ok (apart from the bolt)