SONOFF® IP66 Waterproof Junction Box Waterproof Case Water-resistant Shell
A part of the review has been auto-translated.
Item comes with glands and screws and seal good product
Arrived in good condition
I would give 6 stars to this little box if I could! EXCELLENT quality, well manufactured, no flaws in finishing, weather resistant and I would never find this in my country easily, so thank you! This one goes to protect my NodeMCU personal weather station.
Very nice box and well waterproof. It does hold the Sonoff basic with the housing although it could have been a bit larger. Especially if you use thick wires like I did. Nonetheless it suits the purpose and I could mount the switch in my garden!
The overall quality is pretty good actually and I loved the addition of the silicone filler. The big problem is that it's extremely difficult to mount a POW/Dual/TH series board in this case as there is no room at the end for the incoming wires. I think the design could be improved by either lengthening the box to accommodate the wires or alternatively, locate the holes for the glands at the other end. I'm going to patch the pre-made existing holes and make new ones on the other end or even on one side.
Good quality solid boxes. Need a bit of care fitting the rubber to the lid: Length is ok if fitted properly, but if you find it a bit short just pull out and refit with very slight tension. The glands fit cables 2.5 to 6 mm diameter.
Bought to use as part of teaching my children about renewable energy. I've had 2 outside in the wind and rain for over a month without any problems. I will buy again for other projects.
Nice box but did not expected that it is so small. For comparison I have a sonoff power module. I needed to remove it from case to fit it inside.
I bought it to put the TH16 out in the open as it is watertight but the housing has to be removed and even so, the 2.5mm cables fit hard. On the other hand, you cannot connect the temperature sensor, you have to cut the connector and weld the 3 wires to the plate. In short, for others sonoff may be worth but for this one, better a watertight register box. In any case, it has been in the rain all night and it works, for the moment;)
I used the waterproof case to protect a sonoff basic I have installed inside my kitchen extractor hood to give me smart control over the light. The case gives me peace of mind that the unit will be protected from moisture. The sonoff is a tight fit inside the case, I had to leave the cable clamp covers off. I marked 1 star down for quality as one of the screw heads sealing the case lid did not have the cross slot machined out fully so I could not tighten it with a screwdriver.