NL_Hees 600mw maximum. But adjustable to less as well. In pit mode it sends like 1mw.

NL_Hees That should be no problem. Voltage rarely is an issue, it's the amp draw that will create heath when the wires are too thin. But LED's don't pull that many amps, so in short no issue.

NL_Hees Very helpful answer 🤨 @Lil_red

NL_Hees If you youse a DShot (digital) protocol, you don’t need to calibrate. If the motor still acts weird, swap two motors. If the problem shifts with it, it’s the motor. If the problem stays at the same pl... If you youse a DShot (digital) protocol, you don’t need to calibrate. If the motor still acts weird, swap two motors. If the problem shifts with it, it’s the motor. If the problem stays at the same place it’s the ESC. See More

NL_Hees Could be, but this would mean you crashed your original pagoda antenna it came with. Do check the u.fl pin and if it’s connected to the VTX and check the rest of the pigtail (antenna cable) Also check... Could be, but this would mean you crashed your original pagoda antenna it came with. Do check the u.fl pin and if it’s connected to the VTX and check the rest of the pigtail (antenna cable) Also check your VTX power is on maximum and not 25mw to get maximum range. Hard to say what’s wrong with little info. But like others said could very well be the VTX. If the pigtail is broken or you ran the VTX without an antenna it will destroy itself. So never run a VTX without an antenna connected. The mentioned antenna is not a bad replacement if the antenna is broken. But I find one of the loves break easily in a crash, so if you crash a lot (which tends to happen on a race or freestyle quadcopter) you may want to consider another replacement antenna. See More

NL_Hees Yes. It’s the same dimensions. I have it o my Anet A8 as well.

NL_Hees The camera compartment is made for a full sized camera. Don't know the size by heart but you cuold check the size of a Runcam Eagle 2 pro (not the micro). That is the size of the compartment.