All Messages

Q: is it still use ptfe in the hotend

Asked by pilotgenteng on 2021-01-20 01:07:54

wandery Itdepends on throat type choose: all metal, 3.0 for ptfe tube or ptfe 1.75...

2021-08-28 01:14:05 Helpful (0)
Answers (2)

Q: Hi! whats the difference betwin v 1.2 and v 2.0? thanks!

Asked by Luis Carlos on 2020-08-16 09:05:34

wandery Myv.1.2 has fried after heater cartridge short circuit. Main difference in V2.0 is short protection. See below all upgrades: 1-Use MP1584EN power chip, support 12-24V power input, the maximum output current can reach 2.5A; 2-The hotbed MOS tube uses WSK220N04, low on-resistance, larger heat dissipation area, and reduce heat generation; 3-Onboard Sensorless homing function, which can be used by plugging in the jump cap; 4-Optimize the PCB board and frame to avoid the phenomenon of screw hole gap and screws hitting components; 5-Support touch, filament detection, BTT UPS 24V V1.0, BTT Relay V1.2, etc .; 6-Onboard EEPROM: AT24C32; 7-Add parallel double Z-axis interface; 8-Increase the board layer: 4 layer board; 9-Increase the heat dissipation area of the back driver and strengthen the heat dissipation capacity; 10-Two CNC fan interfaces; 11-Increase the distance between the driving chip and the components to avoid the trouble caused by the heat sink; 12-Add protection device to the thermistor interface; 13-5V power supply with BLtouch, TFT and RGB interfaces is optional; 14-The driver shares a physical UART port, which saves IO and enhances stability.

2021-08-28 01:11:59 Helpful (0)
Answers (2)

Q: Is there a guide/manual with assembly instructions ?

Asked by wandery on 2020-10-30 08:49:58

The seller It is very easy. You could find video on Youtube

2020-11-04 04:59:33 Helpful (0)
Answers (1)