kleinerben
kleinerben There is no 8v pad! There is an solder pad where u can choose the voltage for the vout pad. Its 5v or vbat.
2020-06-30 08:40:33 Helpful (0)Q: Are the DJI receiver signal outputs compatible with typical flight controllers using Betaflight?
Asked by Jhutbeer on 2019-08-25 04:25:05
kleinerben u need one free uart - rx and tx for settings from the uart.. (at this uart enable the msp-protocol in the ports tab) and one sport for the receiver connection. the used sport uart turn on 'serial rx' in ports tab. and set in the config tab the receiver protocol to dji for low latency. in bf 4.1 these changes for dji have been made. additional possibility to show the bf-osd in the googles
2020-04-23 04:47:43 Helpful (1)
kleinerben Yes it does! You can Flash it in INAV
2019-09-11 12:49:51 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
