BG122935392
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

ZOP Power 7.4V 5000mAh 120C 2S Lipo Battery T Deans Plug Hard Case for RC Car
US$23.99 US$33.99

Q: does it come with T to 4.5mm connector wires?

Asked by BG122935392 on 2021-05-20 09:37:59

BG231165414 Yes

2023-02-07 04:28:06 Helpful (0)
Submit
Answers (2)
BG122935392 09/12/2021
Out of the box the camera wasn't working. Disconnected and reconnected the connectors and was working again. looks like they hotglue the vtx antenna connector now so that's good but the vtx heats up pretty quick while getting in to betaflight to configure. Unfortunately they've also oddly hotglued the camera to the vtx board so you can't adjust the camera angle until you separate them. these things are minor however and after remedying that it's great!
21g Eachine UZ65 65mm 1S Whoop FPV Racing Drone BNF Runcam Nano3 35mm Propeller 5.8G 0mw~400mw 48CH VTX
US$129.87 US$125.99
0
Recommendations
Comments (0)

BG122935392 couldn't agree more how confusing it is having flashing led state for normal operation.

Tygrys 07/09/2017
This one is small, weight less 1g. It is AFHDS PPM receiver. It does not have binding button, but if can be bind by the cable connected to the binding pad. Binds with FS-i6X in AFHDS mode with no problem. The only misleading thing is the flashing blue diode in normal connected state. On other receivers flashing diode usually means some abnormal condition, stable connection is signalled by a constant light. To make it more confusing the receiver in binding mode is also flashing fast this diode, succesfull binding is signaled by solid light which seems normal and logical. Despite diode this tiny receiver is working good with FS-i6X.
iRangeX Tiny 2.4G 6CH Flysky Receiver Compatible with Flysky PPM Output for Eachine QX80 QX90 QX95
US$9.59 US$14.99
3
Comments (1)
MATEK Analog Pixel OSD Module 9-30V Support 8V Boost to 12V Voltage Power Regulater for FPV VTX Camera Flight Controller
US$18.89 US$19.99

Q: Will this work with an f3 controller (spracing f3 wizard x220)?

Asked by fabrice.schwaller on 2021-04-27 02:54:21

BG122935392 How? I have not been able to get it to work. Can not pull the correct peripheral "FrSky (OSD)" in the uart ports menu in Betaflight (formware v4.06).

2021-06-18 04:10:53 Helpful (0)
Submit
Answers (2)
MATEK Analog Pixel OSD Module 9-30V Support 8V Boost to 12V Voltage Power Regulater for FPV VTX Camera Flight Controller
US$18.89 US$19.99

Q: I see this is supposed to work with SPRacing F3 and betaflight but there is no way to select "Frsky (OSD)" peripheral in betaflight uart setting as per the instructions. Does anyone have instructions for making this work?

Asked by BG122935392 on 2021-06-18 01:30:44
Submit
Answers (0)
Hobbywing QUICRUN 10BL120 Sensored 120A 2-3S Lipo Speed Brushless ESC For 1/10 1/12 RC Car Parts
US$54.99 US$71.99

Q: does this include the sensor cable?

Asked by BG122935392 on 2021-05-20 01:19:35

Joe no sensor cable

2021-05-20 04:50:06 Helpful (0)
Submit
Answers (1)
SQU OF68 Simulator Universal Car Emulator Signal Reset Immo Programs Place ESL Diagnostic Seat Occupancy Sensor Tool
US$23.91 US$30.99

Q: sounds like some clarification is required for this product. Is this device simply to trick the vehicle into thinking there's someone sitting in a seat that they're not? Also what would be the purpose of that - to disable the safety feature preventing the airbag from deploying when there is no one (or someone too small to register) in the seat? Or does it provide some ability to disable passive immobilizer systems?

Asked by BG122935392 on 2020-11-22 09:28:24
Submit
Answers (0)
BG122935392 07/10/2020
So far they seem great! time will tell how long they hold up as the material is quite thin. In packaging however the overhead long piece was forced into the package and was folded over so it was creased. once installed I couldn't tell so should be fine.
LEORY Earpads Headphone Earmuffs Solf Over Ear Earbuds for Logitech G35 G930 G430 F450
US$8.79 US$13.99
0
Recommendations
Comments (0)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe