All Messages

Q: what is the wireless power chip number?

Asked by Purushottam on 2018-08-04 01:39:45

bamboobernie XKT-510 Available at AliExpress

2021-02-24 02:10:40 Helpful (2)
Answers (3)

AgrawalPurushottam The Second Picture is wiring diagram. And it is explained as under: 1. Test the relay module: connect the relay module VCC to 5V, GND to the ground, and IN to GND, the relay is will beat, if IN is vacant, the relay will restored, so you can hear the “Kaka” sound; 2. Test the soil moisture sensor module: connect the fork probe and transmitter module with two dupont cable, connect the transmitter module VCC to 5V, and GND to the ground. The red power lamp is always on as soon as it is powered on, and the green (blue) led will gleam for once; put the fork probe directly into the water, the green (blue) light will on; 3. Connect the red line of the pump to 5V, black wire to the ground, the water pump will start work. Note that: the test can be performed for 1 second. because it can not expose to the air for a long time. 4. According to the schematic assembly.

2020-07-13 02:37:21 Helpful (0)
Answers (2)

Q: Do I need USB Module Driver for programming this kit?

Asked by Purushottam on 2018-05-10 09:32:43

Botryoidal Yes, you need one.

2018-05-21 01:02:32 Helpful (0)
Answers (1)

Brunovs You can check the File of "Stereoscopic & flat rotating LED debug instruction V1.0.pdf", the problem is the infrared welding on the wrong pipe, Please note that the black receiver tube long foot must connect to negative electrode.

2018-05-19 01:18:59 Helpful (1)
Answers (1)