All Messages

Q: buna ziua,este adevarata 680 nm?, si bateria?

Asked by BG381639331 on 2021-01-30 10:50:31

William Sledge Si , 2 baterias si. 680 nm? Nu este adevărat, mai mult ca 500 nm, nu putea slăbi piulițele de pe Nissan Pathfinder.

2021-01-31 03:26:57 Helpful (1)
Submit
Answers (3)

William Sledge Thank you for the review it is very helpful.

Jan 05/10/2020
I bought this to avoid getting a drill press for the little drilling I do but ended up buying a proper drillpress anyway. Part of the reason for this, is that this tool improves accuracy but it did not get to the accuracy I wanted. The idea is very good that you have two guide shafts that steers the drill down. The power drill attaches straight to the axel so that the concetricty precision does not rely on your exising power tool but the built-in bearing and check. While there is a small amount of play this is not the issue in the big picture. The issue are with the two guide shafts. A) using the drill depth limiter causes, due to compression differences on the depth stop side and the other side, the drill to tilt when pressed down. This can be resolved by removing the depth limiter and relying on the old fasion tape method. B) locking the shaft angles does not result in a very fixed positon. I have found myself drilling slightly slanted holes when I though the shafts were perpendicular to the surface only to find the out of alignment after doing the drill operation. The issue are the plastic angle adjustment items. The dont lock firm and are difficult to check for square. Now it may sound like harsh critisism but I think my expectations were too high for this type of accessory. It does in fact help to drill squarer vs hand held and improves precision but not as much as I wished for. I think it will come useful and I will continue to use it, but for holes truely square against the material and for repeated action I will look to the drillpress.
6
Comments (1)

Q: Sirven para metal?

Asked by byMaXxTer 1563 on 2019-08-12 09:18:36

William Sledge Cal es el angulo?

2020-10-29 01:27:28 Helpful (0)
Submit
Answers (8)