jere69420
yassineahlaou the exact measurements please?
2019-08-29 10:40:33 Helpful (0)
jere69420 edit: works good, only problem was that the cables don't fit on my cr10s so i had to cut the cables and solder the board inbetween, but works really good once installed
Q: Are these compatible with the Cr10?
Asked by Fuu Max on 2019-06-04 04:46:25
Cowabunga It can suit for Nema 17 42 stepper motor. You can refer the parameters to judge if suit for Ender-3 printer.
2019-06-24 01:52:05 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
mainframe Not the top layer no, as an inductive sensor relies on metal. A bltouch is not an inductive sensor, it is a touch sensor. Inductive and capactive sensors can detect surfaces without touching. In short, i would not recommend an inductive sensor with this as the results can be unreliable.
2020-06-05 03:55:50 Helpful (1)