Customer Reviews

4.98 out of 5
Write a Review
  • All Reviews (418)
  • Image (64)
  • Video (0)
  • All Star
    • All Star(418)
    • 5 Star(411)
    • 4 Star(7)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (United Kingdom)
  • May-19 2020 09:58:49

    Good price for the best product.

  • March-10 2020 17:37:16

    great replacement antennas.

  • March-03 2020 13:38:03

    Longitud ideal para colocar la antena entre las patas del drone

  • April-17 2018 01:21:27

    Just what I was looking for. These are the shielded antenna wires but instead of the more expensive braided shielding, this is the cheaper foil shielded antenna replacement. It DOES NOT have and plug on the end (like FrSky uses) instead I soldered the center cable to the existing antenna location, then grounded the shielding to any ground point on the PCB (used cont. tester to locate a ground point) When soldering the foil, use a dab of flux, tin the surface first, and only touch the tip of iron a brief time to avoid melting the plastic tubing. Worked just as I wanted to extend the working portion of the antenna past carbon fiber frame.

  • January-04 2018 02:55:33

    These are great antennas they'll restore your RX to full range after you put the original ones into your props. Very challenging to solder though my picture is magnified 50x and the joins are good... You'll need a bloody small soldering tip and a couple of drinks to steady your hand and you'll be good to go! I think I'll get receivers with the plug type connectors from now on.

  • August-07 2017 08:36:21

    Elle m'ont servit a remplacer les antennes de mon récepteur XSR. Elles sont un peu plus longues mais ça n'est pas dérangeant et elles sont surtout super faciles à souder. Aucun soucis avec. :-)

  • July-11 2018 03:32:08

    Not ipex or pigtail you must be solder directly receiver.

  • May-08 2017 10:07:26

    A propeller cut one of the antennas on my RX, so needed replacements. Price is low and quality looks OK, have not tried them yet. The unshielded part of the antenna is not protected by an extra plastic tube like on the original antennas on my RX, but should not be a problem.

  • July-29 2019 04:14:56

    the soldered part is already non insulated so no worry to cut extra the total length is 15cm why the non insulated part important part is 32mm perfect on all

  • June-23 2017 03:03:35

    Это очень хороший вариант! Дёшево!


    Total 0 pages

    Go to page


    You might be interested in

    recommendation for you
    • £2.97
    • £2.29
    • £1.70
    • £12.53
    • £1.49
    • £1.10
    • £5.72
    • £2.89
    • £23.63
    • £4.02
    • £119.02
    • £10.41
    • £14.87
    • £9.52
    • £8.18
    • £7.43
    • £89.27
    • £2.52