200*200mm Frosted Heated Bed Pad Resistant High Temperature Replace Masking Tape For 3D Printer
A part of the review has been auto-translated.
The quality looks good, the dimensions are correct, as advertised. Large self-adhesive surface, stamped 3M (to see?) Convenient to stick on a mirror, because does not seem rigid enough to be used directly on the bed. Its flexibility would not give it a long life. So to stick on a more rigid support. The surface has a very granular surface for good adhesion. (See close-up photo)
Gostei muito do produto que ainda nao foi testado na impressora 3D. O adesivo é da 3M e parece ser bem forte.
It works great on my Anet A8.
Muito Bom, entregue como o combinado. Chegou em ótimas condições. É de ótima qualidade.
I can not do anything with this because the kink has arrived by very bad packaging Foil was only packed in bag and not protected from kinking.
I had been reading about some of these sticking too well. Tried this with PETG and after cooling down my parts came of nicely. Had to lift them slightly with a metal blade but then they peeled of smoothly. Will use it a couple more days with other filament and see if it stays that way.
Produto chegou rápido e de acordo com o que eu comprei
produto conforme o anúncio vendedor enviou e chegou no prazo!
material de ótima qualidade aderente e é um excelente substituto do vidro.
Это хороший товар с хорошими адгезионными свойствами. PLA прилипает к нему намертво. ABS также держится хорошо.