Now I am ready to build my hydroponics garden (like myvolksgarden)

Now I am ready to build my hydroponics garden (like myvolksgarden)

Now I am ready to build my hydroponics garden (like myvolksgarden)

цена немного высока. блок питания в комплекте слабый для этой ленты. По словам жены эффект есть!

цена немного высока. блок питания в комплекте слабый для этой ленты. По словам жены эффект есть!

цена немного высока. блок питания в комплекте слабый для этой ленты. По словам жены эффект есть!

LEDs work as they should. The adhesive is ok, light level is ok. The presoldered terminals on strip are very convinient. But the transformer is too weaks for the kit. It went hot immeadeatly and stopped working after 72H. Well, it was my mistake to assume that the kit is dimesioned properly. After the transformer failed I did some calculations. the 5050 strip with 60 leds/m pull approx. 72W per 5m strip. The transformer included gives only 60W The rule of the thumb is that the supply should be approx +25% more wattage than the load. At current case the transformer is only 66% of the power it should be to power the whole 5m strip. So instead of good value kit that solves the problem I got a good strip and bad transformer and i still need to spend time to fix the problem

LEDs work as they should. The adhesive is ok, light level is ok. The presoldered terminals on strip are very convinient. But the transformer is too weaks for the kit. It went hot immeadeatly and stopped working after 72H. Well, it was my mistake to assume that the kit is dimesioned properly. After the transformer failed I did some calculations. the 5050 strip with 60 leds/m pull approx. 72W per 5m strip. The transformer included gives only 60W The rule of the thumb is that the supply should be approx +25% more wattage than the load. At current case the transformer is only 66% of the power it should be to power the whole 5m strip. So instead of good value kit that solves the problem I got a good strip and bad transformer and i still need to spend time to fix the problem

LEDs work as they should. The adhesive is ok, light level is ok. The presoldered terminals on strip are very convinient. But the transformer is too weaks for the kit. It went hot immeadeatly and stopped working after 72H. Well, it was my mistake to assume that the kit is dimesioned properly. After the transformer failed I did some calculations. the 5050 strip with 60 leds/m pull approx. 72W per 5m strip. The transformer included gives only 60W The rule of the thumb is that the supply should be approx +25% more wattage than the load. At current case the transformer is only 66% of the power it should be to power the whole 5m strip. So instead of good value kit that solves the problem I got a good strip and bad transformer and i still need to spend time to fix the problem