PeBe
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: Is it normal for the green light to flash every 40 seconds?
Asked by roberto2155 on 2020-04-29 04:27:03
Q: does not pair with sonoff bridge please help.
Asked by roberto2155 on 2020-03-28 06:37:50
PeBe It works great. In the EWELINK application where you have RF BRIDGE, click on RF BRIDGE and then click ADD remote, then ALARM and confirm, then on the newly created remote hold your finger for at least 5 seconds on the bell mark (you will hear the sound). RF BRIDGE will wait a minute to add a SMOKE DETECTOR. In a minute you have to you press the TEST button on the smoke detector. (you will hear the sound again, the pairing sound). Then the connection is complete :)
Helpful (2)
Q: What is the approximate battery life for these?
Asked by DoubleQuad on 2018-03-15 20:16:31
PeBe Igot it, but I haven't started using it yet. but somewhere I read about 4 months, of course depending on usage
Helpful (0)
Q: "Does this work with Alexa?"
Asked by FUN on 2018-08-09 06:03:10
PeBe Iuse it with google home. But yes, the manual says it works with Alexa.
Helpful (0)
PeBe Ithink CN. But where are you from? For example, if you want from EU to Korea, or vice versa, you have to buy another reduction.
Helpful (1)
Q: can i connect it with a sonoff rf switch without the bridge? the switch has also 433mhz
Asked by atik03 on 2020-03-04 03:39:57
PeBe True, you have to use the bridge.
Helpful (0)Q: Cannot adjust sensitivity, no dial where there is + & -. When in smoke alarm not triggering
Asked by TelconetZN on 2020-01-22 09:11:41
PeBe that would interest me as well. it also doesn't respond to smoke.
Helpful (1)
Q: how to pair the Water Sensor sonoff with the bridge
Asked by fernandomaia62 on 2020-01-25 07:07:28
PeBe It works great.In the EWElink application where you have RF BRIDGE, click on RF BRIDGE and then click ADD remote, then ALARM and confirm, then on the newly created remote hold your finger for at least 5 seconds on the bell mark (you will hear the sound).RF BRIDGE will wait a minute to add a WATER sensor. In a minute you have to connect the contacts on the sensor, for example with a cutlery knife :)(you will hear the sound again, the pairing sound)This will make a short circuit, as if the contacts are connected by water.Then the connection is complete.
Helpful (2)
PeBe I don't think it's normal. Mine doesn't do it, but it also doesn't work well for me, as it can't trigger an alarm when it's in smoke. I wouldn't buy it anymore. I wrote a complaint but no one of course.
Helpful (0)