nielsmaneschijn
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: esse osciloscocopio é realmente da marca DANIU?
Asked by BG255010173 on 2022-05-01 05:45:04
Q: does it work for Oculus Quest 2 ?
Asked by paomak20 on 2021-07-26 03:52:48
nielsmaneschijn Works perfectly on Quest 2. Transfers 2,5 Gbps or thereabouts.
Helpful (0)
nielsmaneschijn Just plug it in, worst case it'll turn the wrong way and then you need to either invert the axis in software or swap a random pair of wires.
Helpful (0)
Q: hoeveel is de werkspanning? what is the voltage?
Asked by BG151538311 on 2020-12-26 16:04:02
nielsmaneschijn 12 volt!
Helpful (0)
Q: Does this board except 5V like the WEMOS ESP8266?
Asked by crood58 on 2017-12-26 23:31:06
nielsmaneschijn Yes on the 5V pin, not on the other pins probably.
Helpful (0)
Q: Can you please specify exact dimensions in millimetres?
Asked by BG362214376 on 2020-12-02 06:17:17
nielsmaneschijn Mine is 39.3 by 31.2 mm. 38.9 by 31.2 if you don't include the very slightly protruding USB connector. Max thickness is about 4.2 mm.
Helpful (0)
Q: Do you advise me to buy it?
Asked by Mohamed on 2020-11-18 02:57:54
nielsmaneschijn Yes! It's infinitely more nice than my Mustek 8206 (which is slow as molasses).
Helpful (0)
nielsmaneschijn I had the same, just stir like you're not James Bond and it will mix. Prints fine.
Helpful (0)
nielsmaneschijn Can't tell for sure but it doesn't feel like a knock-off. Works nicely.
Helpful (0)