All Messages

Felicia Current Sense signal configuration in BetaFlight: scale 235, 0.0005 Sampling Resistor, 47k Feedback Resistor.

2018-04-25 01:09:07 Helpful (1)
Submit
Answers (2)

machado.fe This is just a tracker, you need a lot of other things to make it work with whatever setup you have. You need a receiver (depends on your system and frequency), them you need telemetry and you need a battery. This is just an antenna tracker, nothing else.

2020-11-14 12:24:25 Helpful (0)
Submit
Answers (3)

Q: Does this have the IR Block filter?

Asked by machado.fe on 2020-07-12 04:59:08

varefaz no. I had to remove the filter from another broken lens

2020-10-21 05:23:13 Helpful (0)
Submit
Answers (2)

Q: will it pair with the echine tx06 camera?

Asked by Coop on 2020-04-18 09:57:47

machado.fe yes, any 5.8Ghz video transmitter will use frequencies that this google can receive.

2020-04-19 04:45:39 Helpful (0)
Submit
Answers (2)

Q: Is it work for Eachine QX*****CH.

Asked by wahabhaq on 2020-02-26 04:06:45

machado.fe Yes, as any other that transmits in the same analog 5.8ghz

2020-02-26 05:13:38 Helpful (1)
Submit
Answers (8)

Q: is it fit for BR2212 motor ?

Asked by Biswayan Das on 2019-09-27 03:46:34

machado.fe Itdoes not look like. This is a M5 nut, it needs a M5 screw..

2020-01-16 04:50:15 Helpful (0)
Submit
Answers (1)

Q: hacen envío a´l CP 24110 México?

Asked by visanchez on 2018-01-30 06:33:43

machado.fe thisfield is not customer support, it is for other buyers (like me) to exchange product doubts

2020-01-16 04:49:08 Helpful (0)
Submit
Answers (1)

machado.fe It depends on the app you install, there are many. With the "USB Camera" works fine (search on Google Play). Ps.: The image in this receiver is not really "realtime", there is a 100-200ms delay. It is just to watch and record, not to fly with it.

2020-01-16 04:47:45 Helpful (0)
Submit
Answers (2)

Q: compatible with the wizard x220s?

Asked by leopold1120 on 2020-01-02 02:52:41

machado.fe Yes

2020-01-02 02:56:43 Helpful (0)
Submit
Answers (1)

viktorglekler telemetry is not the current sensor. You should connect telemetry pin to uart rx on your flight controller, and configure it.

2019-08-23 04:55:56 Helpful (1)
Submit
Answers (1)

machado.fe Same here, but with the fishbone I cannot make the current sensor to work

2018-04-04 01:48:37 Helpful (0)
Submit
Answers (3)