All Messages

Q: Are these seriously so expensive just for one piece?

Asked by Apotec on 2019-12-04 02:06:09

fureya07 Yup, and they are not worth it. Broke threads in 3 of them in single crash.

2019-12-09 11:51:44 Helpful (1)
Submit
Answers (2)

FPVA Only 12v-28v input yes, but this can be from a car battery to XT60 or from a PC power supply Molex to XT60, as long as its 12v-28v input.

2020-07-15 11:01:58 Helpful (0)
Submit
Answers (8)

Q: can I use this on emax interceptor 1/24 fpv rc car

Asked by smart on 2020-02-11 10:55:05

FPVA Absolutely yes you can, they even have a bundled version where these goggles comes with the rc car... The fpv transmitter on the car is a 25mw 5.8ghz vtx so yes, it will work with these goggles.

2020-07-06 11:01:44 Helpful (0)
Submit
Answers (2)

Q: diversity or not?

Asked by Auridaz on 2020-05-25 08:45:11

FPVA No, not true diversity. It only has one 5.8ghz receiver module inside. It does have antenna diversity only, so you can use two different style antenna's for a little better odds of receiving good signal.

2020-07-06 10:59:10 Helpful (1)
Submit
Answers (2)

Q: hola...es compatible con drone SIRC F11..

Asked by aldana on 2019-08-10 03:33:10

FPVA Unfortunately not, the F11 uses 5g 2.4ghz connection for control and video transmission, much like dji. These goggles are matched for 5.8ghz transmitters only.

2020-07-06 10:56:03 Helpful (0)
Submit
Answers (1)

FPVA Yes, these will work with almost any VTX out on the market as long as its 5.8gigahertz. Make sure however when you get a replacement antenna for the TX805, that you get a set of the same polarization for the Emax too, in other words, left or right hand circular polarized. Right hand polarized works better for me and in general but check with your local fpv flyers to verify for your region.

2020-07-06 10:48:00 Helpful (0)
Submit
Answers (1)

Q: How long is fly time?

Asked by CHESTER on 2020-04-04 02:22:29

Apotec Stock config on 1500mah 120c batt around 4min full freestyle. Once upgraded the esc with JESC and BF4.1.4 and rpm filtering enabled it jumped to around 5:45min for mine with all tpu still installed.

2020-04-04 02:40:36 Helpful (1)
Submit
Answers (1)