All Messages

dirkrider 2020-06-02 13:37:29
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-03-17 04:57:49
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-03-09 17:12:48
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-02-19 08:03:43
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-02-16 10:47:42
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-02-16 10:48:50
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-02-16 10:48:51
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2020-02-05 03:55:51
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-12-09 04:44:02
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-12-09 04:37:30
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-11-19 02:23:50
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-11-19 02:23:49
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: Does it fits for interceptor

Asked by Deepak on 2019-07-13 11:55:41

dirkrider Yourbike's original steering handle should be 22mm size, otherwise, the clamps will not fit. The clamps set may take steering handles of either 22 or 28 mm sizes.

2019-11-01 04:12:45 Helpful (0)
Submit
Answers (1)

Q: what is piston displacement?

Asked by Fredlepp on 2019-10-30 06:14:17

dirkrider Thecylinder capacity of your bike. Formula: Rx R x 3.14159 x stroke or: 1/2 dia piston x 1/2 dia piston x 3.14159 x stroke of your engine. Let's take an example of a 54 mm bore and 54 mm stroke single cylinder bike: 27x27x3.14159x54= 123.67 ccm

2019-11-01 03:37:07 Helpful (0)
Submit
Answers (3)

dirkrider Igot it ( Belgium) in - 1 month of time

2019-11-01 03:37:22 Helpful (0)
Submit
Answers (1)
dirkrider 2019-10-25 12:32:59
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-10-25 10:21:54
0
Recommendations
Comments (0)

Top reviewers you may like:

dirkrider 2019-10-18 05:18:55
0
Recommendations
Comments (0)

Top reviewers you may like:

Q: Thread dimension ?

Asked by sievuun on 2019-10-03 01:48:23

SEYEDIRK The dimension indicated on the photograph is erroneous: inside dia is not 16mm ! You will measure an inside dia of only 14.5mm Thread dimension should be measured at the male piece, this means on the fuel tank: There you will measure outside dia 16mm Thread size is : m16x1.50 (classic Honda standard)

2019-10-04 04:34:31 Helpful (0)
Submit
Answers (1)