All Messages

Q: Can the same remote controll multiple devices at the same time?

Asked by maseaua2113 on 2020-10-19 10:57:25

JanthepBuskin the same remote controll can multiple devices at the same time.

2020-10-30 01:19:54 Helpful (0)
Submit
Answers (1)

Q: Does it come with the orange space bar?

Asked by maseaua2113 on 2020-10-27 03:36:31

The seller Yes.

2020-11-07 02:30:45 Helpful (0)
Submit
Answers (1)

maseaua2113 It also happened to me, but in the end the package arrived. The issue was that they mark it as delivered when the package is delivered to your country delivery sistem. In my case, the national post was involved, which needed 12 days to bring the packet to me 200 miles. Embarasing!

BG541314166 2020-07-21 15:34:24
4
Comments (1)

rokhounds whenever heat is introduced into the cool part of the hot end you will get heat creep which can cause the filament to soften increasing the risk of a clogged hotend. I would suggest lowering your temps to between 195 and 205 max for PLA with about 3mm of retraction and 30mms for retraction speed, then adjust from there as needed. If your retraction is too great you will be pulling softened filament into the cool part of your hotend and it could clog as it cools.

2020-09-22 11:02:05 Helpful (0)
Submit
Answers (2)

rokhounds anytime you have a nozzle with screws connecting it to the cooling tower you run the risk of heat creep which can cause the filament to begin to melt before reaching the hotend and giving you a clog.... if you raise your temps higher then you increase the risk of heat creep happening faster.... i would suggest 195 - 205 max for PLA with retraction of about 3 mm and try 30mms for retraction speed and see what happens.

2020-09-22 10:57:16 Helpful (0)
Submit
Answers (2)