All Messages

ondrej Electric wave clock movement instruction book: (also do not understand, please contact Customer Service) 1. Overview: RCC switch in ON position, with radio wave receiving function, such as dial in OFF position, without radio wave receiving 2. Start: Put the alkaline battery (AA1.5V, LR6) into the battery tank (pay attention to the polarity of the battery), you can see the second hand for sweeping and moving (sometimes you need to press the reset key), after sweeping zero to 12: 00, when the minute needle also starts to sweep zero to 12: 00, the three needles enter the receiving State after scanning zero, and start receiving the radio wave signal. This process takes 3-15 minutes. After receiving the time, the pointer will automatically go to the correct position and start walking. When the RCC switch is turned on the OFF position, the radio wave is not received, and the zero is swept to 12: 0, and the time is immediately gone. 3. Manual adjustment: In the non-sweep, chasing, etc. state, both normal walking time can be manually adjusted. Press the SET key or above more than 3 seconds, all the pointers stop, the minute pin goes 6 times (1 minute), and enters the manual state. When you press and hold the SET key for more than 1 second, the minute and minute hands turn quickly. If you press the SET key below (less than 1 second), add 1 minute. If the user does not operate the SET key and REC key, after about 30 seconds, automatically exit the manual adjustme

2019-12-21 02:04:42 Helpful (0)
Submit
Answers (2)

Q: it have batterys????

Asked by webeyqre on 2018-11-04 01:26:52

fdimarco NO, only case! It is a Kit! DIY

2018-11-05 09:34:44 Helpful (0)
Submit
Answers (1)