BG114675331
Q: is it compatible with rx6r frysky receiver?
Asked by BG114675331 on 2021-07-08 05:54:31
tester Yes
2022-11-03 07:36:42 Helpful (0)
rotor400 RX vom Gps auf TX FC und TX GPS auf RX FC Plus auf 5 Volt Minus auf Ground SLC auf SLC SDA auf SDA.Dann GPS in Iflight Port zuweisen und in Konfiguration GPS aktivieren fertig ist der Akt!
2021-07-29 01:52:59 Helpful (1)
BangingMore No head tracking
2022-02-02 03:39:38 Helpful (0)Q: can i put two 1*****.2v batteries? thanks
Asked by BG114675331 on 2021-04-23 03:17:47
TheGamma Si, es lo recomendable
2022-01-11 02:54:42 Helpful (0)
lucas_ofera14 does fatshark glasses work?
2021-10-22 10:14:44 Helpful (0)
Boo rx to tx and tx to rx (t=transfer to r=receive)
2021-08-05 09:31:52 Helpful (0)
Q: works for frysky rx6r receiver?, thanks
Asked by BG114675331 on 2021-07-08 05:37:36
dengjunbao yes
2021-07-10 01:15:50 Helpful (0)
Q: Hello, good morning, could you tell me if apart from the two-cell battery it admits three? Thanks
Asked by BG114675331 on 2021-04-18 05:58:06
Thrilled I'm afraid not.
2021-05-12 06:47:07 Helpful (0)Q: Hello, good morning, my camera only came with the cable for osd, how can I access the osd? Thank you
Asked by BG114675331 on 2021-04-25 06:46:26
Polo07 Dubrauchst ein 5D Men?kabel. Sollte dabei sein.
2021-05-04 04:24:21 Helpful (0)
lacvo In most configurations, you only need to connect the FC (Matek F765) to your PC with USB cable. in some other configurations, you also need to connect a battery to your FC for testing things like motor, sensors or anything that can not run on USB power
2021-04-26 07:22:39 Helpful (0)
Mugwump not sure.
2021-04-07 10:14:48 Helpful (0)Q: Hello good afternoon, I have to modify the engine and esc to put a 3s battery
Asked by BG114675331 on 2021-03-22 01:12:44
Tricoaster yes.
2021-04-07 10:14:40 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
rhe Mine does that as well. I think it may be an idiosyncrasy in the gyro controlled modes; the rudder stick command appears to demand some yaw movement of the plane, in other words it the rudder angle holds until the plane angle responds (yaw). I also notice a greater range of the rudder servo in gyro stabilized modes. I also had elevator tail wagging in flight. I haven't figured out what makes the tail wagging worse, it seems intermittent. It is probably a result of the gyro feedback gain in the control loop. I haven't tried expert mode (gyro off) yet - still learning my hand eye coordination.
2023-01-03 12:34:01 Helpful (0)