All Messages

armin Bestway to use this TX would be use a ESR Cap on V-Bat and power the transmitter also from your Lipo. My experience is any BCE which has to power Cam and VTX should at least have 1,5 A. Better safe than replace your Flight Controller!

2020-02-19 04:18:00 Helpful (2)
Submit
Answers (2)

Q: are there motor soldering pads (if I want to use single ESCs)?

Asked by tonynux on 2020-04-26 09:14:29

PBlowup If you want to use individual ESC's you will need a PDB for power to you ESC's, I believe the pads marked S1 to S4 would be where you connect the signal wires from the ESC's. If you need ESC telemetry you connect to the RX6 pad. If you want an easier build a 4 in 1 compatible ESC would be a better option. I purchased this board and found that the motors for S1 to S4 are not pinned out to solder pads you can only access these via the ESC plug, however motor S5 to S8 do have connections on solder pads you would need to re-map the motors via the CLI in betaflight to change the motors to S1 to S4.

2020-07-06 09:13:38 Helpful (1)
Submit
Answers (7)

Thurloug Guffaw Actually the flight time is about the same , 3S 450mAh around 6'30-7 mins

2021-02-03 02:02:09 Helpful (1)
Submit
Answers (1)

Q: Is this the 2s toothpick with the longer fly time?

Asked by tonynux on 2021-01-04 08:40:22

alberto86 yes. it's incredibile. with 2 s 500 mah you can freestyle easily for 7.30 .it depends on your skill and speed...i also can fly gently for 9 min and the battery end at 7.1-2 . easily 8.3min with battery at 7.4. it's crazy

2021-01-06 01:20:03 Helpful (0)
Submit
Answers (1)

tonynux yes, it is true. All Happymodel micro-quads have poor VTX range. This is why no more I'll buy (after Mobula6 I already have) their products. This one could be the best toothpick in the market, just with a good VTX range.

2021-01-04 08:32:07 Helpful (0)
Submit
Answers (1)