All Messages

Q: I want to know if it's compatible with OpenTX ?

Asked by popad on 2023-11-19 05:27:16

BG511344559 normalement oui, mais étant donné que ce dernier n'est plus suivi par des mise a jour régulières, tous le monde c'est tourner vers sont fork EDGETX

2024-05-18 04:52:23 Helpful (0)
Submit
Answers (2)

Q: SD card is included ?

Asked by popad on 2023-11-23 01:59:53

Will Dunn Yes and card comes installed

2023-11-26 02:32:17 Helpful (0)
Submit
Answers (1)

popad Link generate an error: "HTTP ERROR 431". Please, give the right link for pdf manual.

2023-10-28 03:02:30 Helpful (1)
Submit
Answers (3)

Q: Can be bind with Jumper T12 ?

Asked by popad on 2021-02-06 10:41:17

Richard I bind them to a Jumper T12 Pro transmitter, which has an inbuilt 4-in1 Multi-protocol module. With a T12 (not Pro) I think you have to put a 4-in-1 module into the bay on the back of the TX.

2021-10-15 08:35:24 Helpful (0)
Submit
Answers (2)

Q: Work with Jumper 4-in-1 Tx module ?

Asked by popad on 2019-11-15 01:48:49

absinth84 yes.it works well

2021-08-26 10:28:27 Helpful (0)
Submit
Answers (1)

Q: How to enable break ?

Asked by popad on 2021-08-21 12:32:36

HazzahFPV Using an Arduino nano or a flight controller you can connect to the ESC via the BlHeli Suite v16.x on your computer. There you can then turn on "Brake on stop". This will short all three motor-phases to ground when throttle is zero, acting as a brake.

2021-08-22 02:55:26 Helpful (0)
Submit
Answers (1)