All Messages

Kalli Thanks!that was very helpful

erberes 25/01/2022
8
Comments (7)

Kalli I've sometimes used a fine tipped sharpie or equivalent pen to dim leds that are too bright. If you have a fine soldering iron you could also try to just unsolder them. But the safest is the sharpie or tape.

2019-10-08 06:39:08 Helpful (0)
Submit
Answers (4)

Kalli The radius is much too large to fit a barrel. Can't measure it for you, but it might fit a narrow stock or thereabouts.

2019-03-07 06:01:20 Helpful (0)
Submit
Answers (1)

Kalli Try the command LoRa.setPins(18, 14, 26); before you do LoRa.begin(868E6); This sets the correct pins, so the LoRa module respons to the begin command, and should work.

2018-06-27 01:45:30 Helpful (3)
Submit
Answers (2)

Kalli You can set the frequency when you initiate the chip in your program. Read the list of commands for the LoRa library, you'll see it. That frequency should be within what this particular chip can you, you won't have a lot of success setting the 868 chip to 433 for example, but 865 should be fine.

2018-06-27 01:43:12 Helpful (0)
Submit
Answers (3)

Q: Is this coming back in stock?

Asked by Kalli on 2018-01-19 07:02:31

Proto_pathy Not anymore

2018-01-23 08:23:22 Helpful (1)
Submit
Answers (1)